.svg){kind=small}
Radial coverage 4 hectares pack installation instructions
Installing the Antenna
(1) Remove the antennas from the packaging and attach them to the antenna connectors on the Access Point (AP). Tighten the antennas in a clockwise direction to securely fasten them in place.
(2) Verify that the antennas are properly tightened. Then, adjust the antennas by bending them at a 45-degree angle to enhance wireless signal coverage.
Connecting the Ethernet Cable
Caution
Ensure that the connector of the Ethernet cable is properly connected to the AP. Incorrect connection of the connector may result in abnormal network connection. When removing the Ethernet cable, first pull it out from the waterproof silicone slot, and then disconnect the RJ45 connector from the AP.
(1) Push the back cover of the AP downwards to remove the back cover.
(2) Remove the silicone pad on the device.
(3) Fully insert the Ethernet cable into the opening of the silicone pad, leaving about 5 cm from the RJ45 connector.
(4) Insert the RJ45 connector into the LAN/PoE port on the device, and then put the silicone pad back into the slot on the device.
(5) Install the back cover of the AP.
Installing the AP
Please note
- The installation site should be free from water flooding, seepage, dripping, or condensation.
- When installing this device, ensure that the antenna end is facing upwards and the device is mounted perpendicular to the ground. Avoid tilting, levelling, or inverting the installation, as it may compromise the device's dust and water resistance performance.
- Power on the device only after it is properly installed.
Mounting the AP on a Wall
The mounting bracket and expansion screws (3.5 mm × 25 mm) are required for wall mounting. Please follow the installation procedure outlined below:
(1) Place the mounting bracket against the wall and adjust its position (pay attention to the designated areas for the AP and antennas). Use a marker to mark the positions for the wall anchors, with the center distance of the mounting hole being 54±0.5 mm (2.13 in. ±0.02 in.). Next, use an electric drill to create a 3.5 mm (0.14 in.) hole.
(2) Attach the mounting bracket to the wall with two expansion screws (3.5 mm × 25 mm).
Caution: When installing the mounting bracket, ensure that the opening of the bracket is facing upwards.
(3) Push and slide the AP downwards to lock it in place. The installation is complete.
Mounting the AP on a Vertical Pole
(1) Thread the band clamp through the hole on the back panel of the AP.
(2) Wrap the band clamps around the pole and pull it tight. The installation is complete.
Checklist After Installation
(1) Checking the AP
- Verify that the external power supply matches with the requirement of the AP.
- Verify that the AP is securely fastened.
(2) Checking Cable Connections
- Verify that the UTP/STP cable matches with the port type.
- Verify that cables are properly bundled.
(3) Checking Power Supply
- Verify that the power cord is properly connected and compliant with safety requirements.
- Verify that the AP works properly when powered by the power supply.
Monitoring and Maintenance
Monitoring
When it is operating, you can monitor its status by observing the LEDs.
Maintenance
If the hardware is faulty, please contact customer support for assistance.
.svg)
